Quick Answer: How Much Does A Blacktop Driveway Cost?

How long does a blacktop driveway last?

12 to 20 yearsAsphalt driveways typically last 12 to 20 years, depending on the quality of the installation, the climate, the usage they get, and how well they have been maintained.

Like most everything else, the better care you take of your asphalt driveway, the longer it will remain in service..

What is the difference between asphalt and blacktop?

Asphalt generally refers to major highways and streets, whereas, blacktop is commonly used to refer to driveways and residential roads. … Blacktop has a higher mixture of stone than asphalt. It also must be heated to a higher temperature, around 300 degrees, than other types.

What time of year should you seal your driveway?

It is recommended to seal your driveway every two to five years. Though, if you can see the color of the stones that make up the asphalt, it is time to seal it again. Ideally the best time of year for driveway sealcoating is between May and October.

What is the least expensive way to pave a driveway?

Of the four paving materials described in this guide, aggregate (gravel) is the least expensive, followed by asphalt, concrete, and paving stones. If you’re installing your driveway on a shoestring budget, gravel is your best choice. If you have more wiggle room, you’ll have more choice.

What does a new driveway cost?

The cost to put in a new driveway averages $4,415, with a typical range between $2,381 and $6,468. For most types, you can expect to pay $2 to $15 per square foot for materials and installation. Driveway prices depend mostly on the material, which ranges from $1 to $50 per square foot, and the dimensions of the area.

Is blacktop cheaper than concrete?

The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. Asphalt prices tend to fluctuate with fluctuations in crude oil prices. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.

How much does it cost to pave a 2 car driveway?

The average cost for a 2-car driveway paving and installation is $3,600 with most homeowners spending between $950 and $7,940. The price can vary greatly by region (and even by zip code). Get free estimates from pros near you.

How much does it cost to pave a 100 foot driveway?

Other sources estimate the cost to install an asphalt driveway to be between $2,300 and $10,300. Homeowners typically pay per square foot. Reibling adds the average cost per square foot is between $3.50 and $4.50. Some asphalt contractors may charge by the ton, with the cost ranging from $100 to $150 per ton.

Does paving driveway increase home value?

Asphalt driveways can last you 20-25 years if properly installed and maintained – a great investment. … While they increase the value of your home, a nice paved driveway can also help sell your home FASTER.

How much does it cost to pave a driveway with cement?

The most basic method ranges from $10 to $12 per square foot.

How much is a blacktop driveway?

The national average for installing an asphalt driveway costs about $3 to $5 per square foot. For a standard 10-foot by 20-foot driveway, big enough for a single car, that means you’ll spend between $600 and $1,000.

What is the cheapest driveway surface?

2. Gravel. This is one of the cheapest alternatives to asphalt driveways by far, costing very little to have installed. The average gravel driveway consists of hard, angular gravel laid throughout the driveway.

How much does it cost to pave a 2000 sq ft driveway?

Paving an asphalt driveway costs $4,717 on average, with a typical range between $2,930 and $6,556. This project runs $7 to $13 per square foot, including $2 to $6 per square foot for materials and $5 to $7 per square foot for labor. If you need replacement, you’ll pay $8 to $15 per square foot.

Is 2.5 inches of asphalt enough for a driveway?

For a regular driveway which is going to be used by regular cars, bicycles and bikes; 2 inches of asphalt is thick enough. Generally for resurfacing, 2 inches of asphalt is just about right, but if you are going for a stone surface and need a good base, it is better to layer up the asphalt thicker, around 3 inches.

How much does it cost to pave 1 acre?

The PAVE-A-LOT works just as well as the expensive units but sells for a fraction of the cost. Every aspect of the PAVE-A-LOT is easy to learn and the paving can be done at your convenience. This method of paving will save you at least half the cost, which is about $10,000.00 to $12,000.00 per acre.

How much does it cost to pave a 50 foot driveway?

Average Driveway Paving CostDriveway TypeCost Per Square FootGravel$.50-2Asphalt$1-5Concrete$3-10Pavers or Bricks$10-50

Can I pave my own driveway?

DIY paving is possible in certain situations, although you can’t go wrong when hiring an experienced paving contractor. A properly installed paved driveway will add value to your home and last for years with minimal maintenance. Consider whether your own efforts will produce a driveway of this quality.

How much does it cost to pave a 1/4 mile driveway?

An asphalt driveway costs about $2-$5 a square foot, or $1,200-$3,000 for 12’x50′ to $31,000-$75,000 for a 12′ lane a quarter mile long.